Prusament Blended PLAs have a new formula since September 1, 2020. The material density is now slightly lower than before, resulting in a minimal spool weight of 970 g. The approximate length of the filament is 330 m – the same length as the standard non-blended Prusament.
Prusament PLA Blend is our own in-house made filament. The whole manufacturing process is closely monitored and tested – we guarantee ±0.03mm precision and highly-consistent colors
Prusament PLA is our own in-house made filament. The whole manufacturing process is closely monitored and tested – we guarantee ±0.02mm precision and highly-consistent colors. You can inspect parameters of every spool we made at prusament.com.
- Material: PLA
- Diameter: 1.75 mm
- Precision: ± 0.02 mm
- Heated build platform required: No
- Print temperature: 200°C – 220°C
- Weight filament: 1000 g
What is PLA?
PLA is biodegradable, and the material on its own is food safe, we do not suggest to repeatedly drink or eat from your 3D prints. Because of the small fractures on the print surface, bacteria can build up in there over time. You can prevent this by applying a food-safe coating. When post-processing PLA, it’s better to use wet sanding. Without water you’ll quickly start heating the plastic by friction, it will melt locally and make it hard to keep sanding.
PLA melts at a relatively low temperature of about 175 degrees Celsius. Unlike so-called thermoset materials, PLA can be heated past its melting point multiple times with very little degradation. It’s a hard material, but that also means it’s somewhat brittle, and once it breaks, it likes to shatter. Only this material is proven for 50 microns layer height.
However, PLA is not a perfect material and, just like every other plastic, has some disadvantages. The low melting temperature also means low-temperature resistance. Parts start to lose mechanical strength at temperatures over 60 °C.
The combination of being both biodegradable and having low-temperature resistance means that it’s not ideal for outdoor use, not to mention low UV-resistance. Also, PLA is only soluble in chemicals like chloroform or hot benzene. So when connecting multiple pieces, you’re better off using just glue.