Tilbud

Me RJ Adapter V2.1

96,00 kr.  Ekskl. moms 79,20 kr.  Ekskl. moms

Me RJ25 Adapter modul konverterer den almindelige standard RJ25 port i seks pins (VCC, GND, S1, S2, SDA, and SCL) så de nemt kan forbindes med andre Makeblock porte eller med andre elektronik fabrikanter end Makeblock. Det betyder vi nemt kan forbinde ting som temperatur sensor, servo motorer og meget mere. RJ25 modulet skal forbindes med et Makeblock board via portene gul, blå eller sort ID.

Det understøtter de fleste Arduino programmerings værktøjer (Arduino/Ardublock) og giver GUI programmeringsværktøjet (mBlock) som er en udvidelse af Scratch.

En sjov og lærerig tilføjelse til din Makeblock Robot om det så er mBot, Ultimate robot eller Starter Kit

Husk vi hjælper gerne i Kidsprint med inspiration til programmering og sjove projekter – se også vores Blog eller skriv til os

Overview

The Me RJ25 Adapter module converts the standard RJ25 port into six pins (VCC, GND, S1, S2, SDA, and SCL) so that they can be easily drawn out from MakeBlock port in compatible with electronic modules from other manufacturers, such as temperature sensor and servo module. This module should be connected to the ports with yellow, blue, or black ID on Makeblock Orion.

Technical specifications

● Operating voltage: 5V DC
● Maximum current: 3A
● Space between pins: 2.54 mm
● Module size: 51 x 24 x 18 mm (L x W x H)

Functional characteristics

● Red LED is power indicator
● Provide I²C port and two digital/analog ports
● Can connect to electronic modules of other manufacturers
● White area of module is the reference area to contact metal beams
● Two 3-pin anti-reverse base
● Support mBlock GUI programming, and applicable to users of all ages
● Adopt RJ25 port for easy connection

Pin definition

The port of RJ25 Adapter module has 6 pins, and their functions are as follows:微信截图_20160128162813

Wiring mode

微信截图_20160128163016

Guide to programming

● Arduino programming
If you use Arduino to write a program, the library Makeblock-Library-master should be invoked to control the Me RJ25 Adapter.
This program serves to read the state of Limit Switch and output results to the serial monitor in Arduino IDE through Arduino programming.微信截图_20160128163321微信截图_20160128163428

The function of the code segment is: to read the state of Limit Switch and output results to the serial monitor. Upload the code segment to Makeblock Orion, click the serial monitor and you will see the running result as follows:微信截图_20160128163703

● mBlock programming
Me RJ25 Adapter supports the mBlock programming environment and its instructions are introduced as follows:微信截图_20160128163747

Principle analysis

The Me RJ25 Adapter module lead out 6 IO ports of Makeblock Orion, they are SDA, SCL, GND, VCC, S1, and S2 respectively. S1 and S2 can be used as input/output of digital/analog signal; SDA is I²C data bus, SCL is I²C clock bus, and they can be connected to sensors which support I²C bus. For example, the Me Temperature Sensor-Waterproof module supporting I²C protocol can be connected to the I²C bus in series to construct a network for temperature measurement.

Schematic

s2

Yderligere information

Vægt 450 g
Størrelse 25 × 20 × 15 cm

Du kunne også være interesseret i...

  • Tilbud